Page 8 - CEAST 9340 - Instructions for Use and Maintenance 7510.000MN1r ed. 1 rev. 1
1. GENERAL INFORMATION
Description: CEAST 9340
Manufacturer: ITW Test and Instrument Italia S.r.l. - INSTRON CEAST
Division
Type: Droptower Impact System
Code: the code number of the instrument can be found on the ID
plate (on the rear panel)
Registration: the registration number of the equipment can be found on
the ID plate (on the rear panel)
Electric Service: 230 V / 50 Hz - single phase
Identification
Conformity
Field of
application
Authorized
Service
Centers
Contact your nearest Instron CEAST Division Sales and Service office or
contact your local distributor: a list of Instron CEAST Division offices is
available on our websites: www.ceast.com and www.instron.com.
Markings
The plate with the CE marking and the identification information is located
on the rear panel of the instrument (see the figure below).
Indication
of danger
due to
electric
shock
On the instrument there are plates with various danger signals. These
plates act to advise the user and the maintenance personnel of the type of
danger that exists in the local area next to the plate.
Physical contact with parts of the equipment that have electrical current
can cause immediate death or permanent wounds. Safety protection, fixed
panels, flaps or doors that have this signal can be removed or opened only
and exclusively by “Maintenance Personnel, qualified or trained” after dis-
connecting the instrument from the electrical service and removing the
plug from the electrical socket.
The equipment is used for instrumented and not instrumented impact tests
on plates, films specimens and tridimensional parts of thermoplastic ma-
terials.
See the “Conformity Declaration” attached
To Next Page
Loading...
