Page 38 - CEAST 9340 - Instructions for Use and Maintenance 7510.000MN1r ed. 1 rev. 1
8. USE
8.1 SAFETY STANDARDS
The general safety norms outlined in the introduction pages of this manual are
valid.
All work procedures that would compromise the safety of the instrument must be
avoided.
The OPERATOR must ensure that no unauthorized personnel work on the instru-
ment.
The OPERATOR is obliged to check the instrument at least once per work shift to
ensure that there is no visible external damage. Any eventual secondary modifi-
cations (including work methods) that compromise the safety must be immedi-
ately reported.
The instrument can be used only if it is in perfect condition.
The user must follow all instructions and checks in order to guarantee the cleanli-
ness and visibility of the work station where the instrument is located.
The protections may not be removed or altered.
Should there be damage or breakdown of a component, the instrument must be
removed from use until it is once again in perfect working order. If during installa-
tion, repair or maintenance it is necessary to dismantle the instrument, for safety
reasons it must be removed from service, following with precision the relative in-
structions. At the end of the intervention, the instrument must be immediately re-
assembled and checked for correct functioning .
For safety reasons, it is forbiden to change
or modify any part or portion of the instrument
To Next Page
Loading...
