CEAST 9340 - Instructions for Use and Maintenance 7510.000MN1r ed. 1 rev. 1 - Page 33
6.4 STABILITY
The instrument is stable if placed with all four feet touching a planar surface.
6.5 CLEANING
6.6
MATERIALS AND PRODUCTS
The instrument does not require cleaning with protective substances (e.g.: grease or oil
on the surfaces). In any case, should it become dirty during installation, clean the sur-
faces with a soft cloth and non-corrosive and not dangerous detergent that will not
damage the painted surfaces. In any case all safety indications provided by the manu-
facturer of the cleaning solutions must be followed.
The instrument is primarialy constructed from: iron, steel, aluminium, copper, light alloys
and thermal insulation (for environmental chamber only) not containing asbestos.
External parts of the environmental chamber are painted. The maximum external tem-
perature that can be reached by these parts is approximately 40°C, a temperature at
which the paint does not emit toxic vapors or fumes.
Cables and electric components meet the international standards.
The disposal of the materials must be done by the CUSTOMER, according to the local
environmental laws of the COUNTRY in which the instrument is located.
Don’t Litter. Recycle.
It is the responsibility of the CUSTOMER to verify that the floor is able to
carry the weight of the instrument (see paragraph 6.2.1).
Fig. 3
(detail B)
Adjustable
wrench
Foot exagonal nut
Exagonal lock nut
Fig. 3
(detail A)
Forklift
Fig. 3
To Next Page
Loading...
