Page 176 - CEAST 9340 - Instructions for Use and Maintenance 7510.000MN1r ed. 1 rev. 1
List of Error Codes (Movements/Process Errors. They cause the test to stop) 3 of 4
Code Error Cause Remedy
500 TV error: emergency stop
502 TV: crosshead encoder
zeroing not performed
504 TV: crosshead calibration
height too low
505 TV: crosshead calibration
height too high
524 TV: instable TV positioning
525 TV: instable TV stop position
531 TV error: fc upper
532 TV error: fc lower
533 TV error: fc lower (SW)
534 TV error: fc upper (SW)
535 TV error: on upp. FC up is
requested
536 TV error: on low. FC down is
requested
550 TV: crosshead target
movement under limit with
Shutter closed
551 TV: down command with
striker yet found
552 TV: crosshead target
movement under limit with
Antirebound set
581 TV: encoder disconnected,
motor blocked or direction of
rot. conflict
582 TV: wrong encoder direction
To Next Page
Loading...
