Instron CEAST 9340 - Page 73

CEAST 9340 - Instructions for Use and Maintenance 7510.000MN1r ed. 1 rev. 1 - Page 73
g) Enter the calculated value “X” as “Crosshead Position (z)” parameter in the
“Move to height” function (see para. 8.5.17).
h) Alternative mode to paras. f) plus g): enter “0” (zero) as “Striker Position”
(Hc parameter, see para. 8.5.17).
i) Press the “Start” key to positioning the striker.
j) Adjust the height of the stand until the specimen surface touches the striker
end.
k) Lock the stand using the locking handles.
l) Press the “Home” key to move the striker at the rest position.
X
X
X
X
X
X