IRIS iQ 200 Sprint

To Next Page

To Previous Page

Iris Diagnostics, a Division of Iris International, Inc.

200 Sprint™ (2G) Automated Urine Microscopy Analyzer Service Manual 300-4949 Rev A 01/2005 4

Table of Contents

Procedure...........................................................................................................4-8

STD Verification Procedure................................................................................4-9

Specimen Presentation Assembly (SPA) and Waste/Rinse Well Calibration ..4-10

Material required ..............................................................................................4-10

Procedure.........................................................................................................4-10

Waste Well Positioning.....................................................................................4-10

Test Tube Centering Position...........................................................................4-11

Test Tube Depth Positioning ............................................................................4-11

Waste Well Depth Positioning ..........................................................................4-12

Lamina Consumption Adjustment ....................................................................4-12

Air Pressure Calibration ...................................................................................4-13

Material required ..............................................................................................4-13

Procedure.........................................................................................................4-13

Barcode Reader Alignment ..............................................................................4-14

Material Required .............................................................................................4-14

Procedure.........................................................................................................4-14

Prepare Barcode Reader Connections ............................................................4-14

Load the Alignment Tool ..................................................................................4-15

Perform barcode alignment ..............................................................................4-15

Validation..........................................................................................................4-18

Collimation........................................................................................................4-19

What is a Collimation?......................................................................................4-19

Condenser Alignment.......................................................................................4-19

Run Auto Focus................................................................................................4-20

Flow Cell Replacement ....................................................................................4-21

Flow Cell Removal ...........................................................................................4-21

Flow Cell Installation ........................................................................................4-21

Flow Cell Lateral Adjustment............................................................................4-22

Flow Cell Tilt Adjustment..................................................................................4-23

5 - Service Application Software

Accessing the Service Screen............................................................................5-3

Startup................................................................................................................5-3

Establishing Link ................................................................................................5-4

Live Operation ....................................................................................................5-5

Tree View Pane..................................................................................................5-5

Commands .........................................................................................................5-6

Preset Moves .....................................................................................................5-6

Sensors ..............................................................................................................5-6

Calibration Table ................................................................................................5-7

Calibration Auto-Sets .........................................................................................5-7

Sequences .........................................................................................................5-7