Javad Maxor - Page 10

vi Maxor Operator’sManual www.javad.com
LIST OF FIGURES
Advanced Configuration – Loop Management ............ 2-17
Maxor MinPad .............................................................. 2-19
Connection Parameters – RTS/CTS Handshaking ....... 2-20
Configuration->Receiver .............................................. 2-20
Receiver Configuration – MinPad Tab
............
............ 2-21
Radio Link Tab ............................................................. 2-28
Modulation Type .......................................................... 2-28
Serial Interface Tab ...................................................... 2-30
FCS Tab ......
.................................................................. 2-31
FCS Tab ........................................................................ 2-34
GSM Tab ...................................................................... 2-35
GSM Tab ...................................................................... 2-37
File->Manual Mode ...................................................... 2-38
Bluetooth® Module Configuration Main Screen .........
2-40
Select Communication Port and Click Connect ........... 2-41
BTCONF Identification Tab ........................................ 2-42
BTCONF Parameters Tab ............................................ 2-42
BTCONF Security Parameters ..................................... 2-43
BTCONF Serial Interface Tab ..................................... 2-43
Chapter 3. Setup and Measuring
Maxor GD and Maxor GGD Antenna Offsets ............. 3-3
MarAnt+ Antenna Offset Measurements ..................... 3-5
Configuration->Receiver .............................................. 3-6
Select External Antenna Option ..............
..................... 3-6
Configuration->Receiver->MinPad ............................. 3-8
Advanced->Multipath .................................................. 3-9
Advanced->Loop Management .................................... 3-10
Rover MinPad Configuration ....................................... 3-11
Set All Parameters to Defaults ................
..................... 3-14
Receiver Configuration – Positioning .....
..................... 3-15
Base Tab Configuration ................................................ 3-16
Base Configuration – Ports ..................
......................... 3-17
Rover Tab Configuration .............................................. 3-18
Rover Configuration – Ports ......................................... 3-19