3 Basic Operation of ECDIS 3-145
ECDIS
Button Operation (left-click the button):
[Filter]: The “Logbook Setting” panel opens. You can set the filtering conditions. For
logbook option settings, see the next 3.26.2 “ Logbook Setting”.
[Column Setting]: You can select any item in the list. Left-click the item to turn it ON or OFF.
The check mark (✔) shows that the selected item is set to ON. Selected
column and [Up] or [Down], The column changes the order in table of
“Logbook” panel
Column list is as follows:
・ Date
・ Time
・ Event
・ POSN1
・ POSN2
・ Latitude
・ Longitude
・ COG(°)
・ SOG(kn)
・ Heading(°)
・ Log(kn)
・ Av. Speed 4h(kn)
・ Av. Speed 24h(kn)
・ Voyage DIST.(G)(NM)
・ Voyage DIST.(W)(NM)
・ Charts, Set(°), Drift(kn)
・ Wind Dir. (°)
・ Wind Speed(m/sec)
・ Wave Dir. (kn)
・ Wave Height(m)
・ Air Press Temp.(hPa)
・ Tem p(℃), Water Temp.(℃)
・ Engine Rev.(rpm)
・ Comments
・ Wave Height(m)
・ Air Press .(hPa)
・ Air Temperature (℃)
・
Water Temperature.(℃)
・ Engine Rev.(rpm)
・ Comment
Following column can not move:
・ Date
・ Time
[OK] : It saves setting contents.
[Cancel] : It cancels setting contents.
To Next Page
Loading...
