4 Route Planning
4-48
How to edit in the Graphic Editing Menu -- Continued:
Designating coordinates by entering the position or entering the bearing/distance:
Positions can be designated by entering the position or entering the bearing/distance instead of
left-clicking on the chart to designate a coordinate when entering, moving, inserting and adding route.
Designating coordinates by entering position
1) Make sure the system will accept cursor designation of coordinates when entering, moving,
inserting and adding route. (Make sure that the cursor has changed to the
cursor type on
the chart.)
2) Click the right trackball button, then select [Enter Lat/Lon] from the shortcut menu.
The “Enter Position” panel opens.
3) Enter the position (longitude and latitude), then left-click the [Enter] button the position is
designated..
Left-click the [Close] button the panel is closed.
Designating coordinates by entering bearing/distance
1) Make sure the system will accept cursor designation of coordinates when entering, moving,
inserting and adding route. (Make sure that the cursor has changed to the
cursor type
on the chart.)
2) Click the right trackball button, then select [Enter Bearing/Distance] from the shortcut menu.
The “Bearing/Distance” panel opens.
3) Enter the bearing and distance from the previous way point, then left-click the [Enter] button.
the position is designated.
Left-click the [Close] button the panel is closed.
Note:
• When entering the second way point of a route, the bearing and distance are those from the
previous way point. The shortcut menus cannot be used when designating coordinates that do
not require relative positions, such as the first way point of route.
To Next Page
Loading...
