5 Chart Editing
5-31
ECDIS
(2) How to draw lines
Drawing lines:
1) Select one of the objects on the line selection panel.
•Be sure that the “cursor” column is displayed “Make Map”.
2) Rotate the trackball to move the cursor, and left-click at the position you want to start drawing a
line.
Each time you left-click the cursor, the line is extended on the chart.
3) Left-click twice quickly to stop to extend the line.
4) To abort, right-click the trackball and select [Abort] from the pop-up menu. Then, the “cursor”
column is displayed nothing.
Tips! (Moving the chart)
• Click the left trackball button while drawing lines. A hand icon will be shown on the chart.
Move the trackball while holding the left button down to move the chart.
Deleting the line [Delete]:
1) Left-click the [Delete] button.
• Be sure that the “cursor” column is displayed “Delete Map”.
2) Left-click the line you want to delete.
3) To abort, right-click the trackball and select [Abort] from the pop-up menu. Then, the “cursor”
column is displayed nothing.
Tips! (Moving the chart)
• When it is difficult to properly click on the segment you wish to delete, press the Chart [Zoom In]
button provided on the right side of the display panel. This will allow you to click on the target
segment easily.
To Next Page
Loading...
