JRC JAN-701B - Page 358

5 Chart Editing
5-32
Inserting the segment [Insert/Move Vertex]:
1) Left-click the [Insert/Move Vertex] button, and rotate the trackball to move the cursor.
•Be sure that the “cursor” column is displayed “Insert/Move VTX”.
2) Left-click the segment you want to insert an additional segment.
3) Left-click the cursor at the position you want to add the segment.
4) To abort, right-click the trackball and select [Abort] from the pop-up menu. Then, the “cursor”
column is displayed nothing.
Moving the Vertex [Insert/Move Vertex]:
1) Left-click the [Insert/Move Vertex] button, and rotate the trackball to move the cursor.
•Be sure that the “cursor” column is displayed “Insert/Move VTX”.
2) Left-click the segment you want to move the vertex.
3) Left-click the cursor at the position you want to move the vertex.
4) To abort, right-click the trackball and select [Abort] from the pop-up menu. Then, the “cursor”
column is displayed nothing.
Adding the segment (to the end of the line) [Add]:
1) Left-click the [Add] button, and rotate the trackball to move the cursor.
•Be sure that the “cursor” column is displayed “Add VTX”.
2) Left-click the last segment of the line.
3) Left-click the cursor at the position you want to add the segment.
Each time you left-click the cursor, the new segment is added.
4) Left-click twice quickly to stop to add the new segment.
5) To abort, right-click the trackball and select [Abort] from the pop-up menu. Then, the “cursor”
column is displayed nothing.
(When you left-click the cursor.) (When you left-click the cursor.)
Edit