5 Chart Editing
5-36
(4) How to draw areas -- Circle and Ellipse
1) Select Circle or Ellipse on the area selection panel.
•Be sure that the “cursor” column is displayed “Make Map”.
2) Move the cursor and left-click at the center position of the circle/ellipse.
3) To draw a circle, move the cursor to determine the radius of the circle and left-click the cursor.
To draw an ellipse, move the cursor and left-click the cursor.
4) To abort, right-click the trackball and select [Abort] from the pop-up menu. Then, the “cursor”
column is displayed nothing.
5) To change the location/attributes of the circle or ellipse, Left-click the [Property] button, and
Left-click the inside of the area to select it.
Then, the “Location/Attributes” panel opens.
(Left-click the cursor.) (Ellipse)
[“Location/Attributes” panel for Circle/Ellipse]
• You can edit the latitude and longitude of each object by entering position latitude and
longitude.
• You can edit the Horizontal/Vertical of the ellipse. (Not for the circle but for the ellipse only)
• You can set Min Scale and Max Scale that limit the display of this object.
• You can change the attributes, line color (8 colors), line width (5 widths) and line style (3
styles).
• You can change the color to be filled in the area (8 colors) and the transparency of the color
(0%, 25%, 50%, 75%).
• You can enter a comment.
6) Left-click the [OK] button to close the panel.
Then, the object changes according to the location/attribute settings.
(Same color but Transparency differs)
0% 50%
(Draw Circle)
To Next Page
Loading...
