JRC JAN-701B - Page 363

5 Chart Editing
5-37
ECDIS
(5) How to draw areas -- Fan
1) Select Fan on the area selection panel.
•Be sure that the “cursor” column is displayed “Make Map”.
2) Move the cursor and left-click at the center position of the fan.
3) Move the cursor to determine the radius and beginning angle of the fan and left-click the cursor.
4) Move the cursor to determine the ending angle and left-click the cursor. Then, area is created.
5) To abort, right-click the trackball and select [Abort] from the pop-up menu. Then, the “cursor”
column is displayed nothing.
6) To change the location/attributes of the fan, Left-click the [Property] button, and Left-click the
inside of the area to select it.
Then, the “Location/Attributes” panel opens.
•
Case 1
•
Case 2
[“Location/Attributes” panel for Fan]
• You can edit the latitude and longitude of each object by entering position latitude and
longitude.
• You can edit the Horizontal/Vertical and angle of the fan.
• You can set Min Scale and Max Scale that limit the display of this object.
• You can change the attributes, line color (8 colors), line width (5 widths) and line style (3
styles).
• You can change the color to be filled in the area (8 colors) and the transparency of the color
(0%, 25%, 50%, 75%).
• You can enter a comment.
7) Left-click the [OK] button to close the panel.
Then, the object changes according to the location/attribute settings.