JRC JAN-701B - Page 480

9
Reference
9-64
Set value list when starting ECDIS - Setting Menu (continued)
No. Category Contents Set when starting
82 Route Planning –
Table Editor
- -
83 Route Planning –
Graphic Editor
- -
84 Create Alternate Route - Cannot be selected
85 - Cannot be selected
86 From Way Point
87 From - WPT No. 00
88 To Way Point
89
Distance Measurement
To - WPT No. 00
90 Use XTD Alarm (ON/OFF) The value when ending last time
91 Date/Time for monitoring The value when ending last time
92 Select Route -
ETA (ON/OFF)
The value when ending last time
93 Default - Width Prt The value when ending last time
94 Default - Width Stb The value when ending last time
95 Default - Arr Radius The value when ending last time
96 Default - Speed The value when ending last time
97 Default - Sail The value when ending last time
98 Default - Turn Rate The value when ending last time
99 Default - Turn Radius The value when ending last time
100 Default - Time Zone The value when ending last time
101 Max. Latitude The value when ending last time
102 Tau Multiplier for Limit Check The value when ending last time
103 Check Safety
in Editing (ON/OFF)
The value when ending last time
104 Route Type The value when ending last time
105 Side Sign Color The value when ending last time
106
Route
Setting
Display Side Sign (ON/OFF) The value when ending last time
107 Adjust - Cursor - -
108 LAT Current Position of Own ship
109
Adjust - Enter Position
LON Current Position of Own ship
110 LAT The value when ending last time
111
Adjust - Enter Offset
LON The value when ending last time
112
Ownship/
Track
Anchor Watch –
Create Monitoring Circle
Radius The value when ending last time