Table 5: CLI Equivalents of Terms Used in Documentation for EX2200 Switches (continued)
Additional
Information
Item in
Documentation
Value (as displayed
in the CLI)
Description (as
displayed in the CLI)
Hardware Item (as
displayed in the CLI)
Understanding Interface
Naming Conventions on
EX Series Switches
The switch does not
have actual FPCs. In
this case, FPC refers to
the switch itself.
Value of n is always 0.Abbreviated name of
the Flexible PIC
Concentrator (FPC)
One of the following:
•
EX2200-C-12T-2G
•
EX2200-C-12P-2G
•
EX2200-24T-4G
•
EX2200-24P-4G
•
EX2200-24T-4G-DC
•
EX2200-48T-4G
•
EX2200-48P-4G
FPC (n)
Understanding Interface
Naming Conventions on
EX Series Switches
The switch does not
have actual PIC
devices; see entries for
PIC 0 through PIC 1 for
the equivalent item on
the switch.
n is a value in the range
of 0–1.
Abbreviated name of
the Physical Interface
Card (PIC)
PIC (n)
“EX2200 Switches
Hardware Overview”
on page 3
Built-in network ports
on the front panel of
the switch
PIC 0One of the following:
•
12x 10/100/1000
BASE-T
•
24x 10/100/1000
BASE-T
•
48x 10/100/1000
BASE-T
“EX2200 Switches
Hardware Overview”
on page 3
Built-in uplink ports
and dual-purpose
uplink ports on the
front panel of the
switch
PIC 1One of the following:
•
2x (10/100/1000
BASE-T or GE SFP)
or
•
2x (100/1000
BASE-X)
•
4x GE SFP
“Pluggable
Transceivers
Supported on EX2200
Switches” on page 26
Optical transceiversn is a value equivalent
to the number of the
port in which the
transceiver is installed.
Abbreviated name of
the transceiver
Xcvr (n)
“Power Supply in
EX2200 Switches” on
page 18
AC power supplyValue of n is always 0.Built-in power supplyPower supply (n)
11Copyright © 2015, Juniper Networks, Inc.
Chapter 1: EX2200 Switch Overview