Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 User Manual

destination-addressdestination-port, event-type rule-set: rule-set-name, rule: rule-name,
term: term-name
Description A packet matched the indicated term in the indicated Network Address Translation (NAT)
rule. If the rule belongs to a rule set, the rule set name is also displayed. The matching
packet contained the indicated information about its protocol (numerical identifier and
name), application, source (logical interface name, IP address, and port number), and
destination (IP address and port number).
Type Event: This message reports an event, not an error
Severity info
Facility LOG_PFE
ASP_PGCP_IPC_MSG_WRITE_FAILED
System Log Message Unable to write IPC message (type message-type, subtype message-subtype): status
code status
Description The Packet Gateway Control Protocol (PGCP) client on the MultiServices Physical
Interface Card (PIC) could not write an interprocess communication (IPC) message to
the end of its pipe.
Type Error: An error occurred
Severity error
Facility LOG_PFE
ASP_PGCP_IPC_PIPE_WRITE_FAILED
System Log Message Unable to write IPC message (type message-type, subtype message-subtype) to pipe:
status code status
Description The Packet Gateway Control Protocol (PGCP) client on the MultiServices Physical
Interface Card (PIC) could not write the contents of its interprocess communication
(IPC) pipe to the socket layer.
Type Error: An error occurred
Severity error
Facility LOG_PFE
ASP_SFW_ALG_LEVEL_ADJUSTED
System Log Message ALG sfw-application-name specified by stateful firewall or CoS rule was reduced to
nat-application-name, because twice NAT does not support ALG application
Description A twice Network Address Translation (NAT) rule is applied to the same source or
destination addresses as a stateful firewall or class-of-service (CoS) rule that applies
an application-level gateway (ALG) other than Internet Control Message Protocol (ICMP)
or traceroute. The configuration is invalid, because only those ALGs are supported in
combination with twice NAT. The ALG configured in the stateful firewall or CoS rule was
ignored, and only the application configured in the twice-NAT rule was applied. The
Copyright © 2010, Juniper Networks, Inc.86
Junos 10.3 System Log Messages Reference

Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Specifications

General

Brand	Juniper
Model	JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010
Category	Software
Language	English