Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 User Manual

adaptive services software accomplished this internally by adjusting the indicated ALG
value (which is not supported with twice NAT) to the indicated supported value.
Type Event: This message reports an event, not an error
Severity warning
Facility LOG_PFE
Action Change the configuration so that twice-NAT rules (defined at the [edit services nat]
hierarchy level) are not applied to the same source or destination addresses as rules
defined at the [edit services stateful-firewall] or [edit services cos] hierarchy level that
include ALGs other than the supported ones.
ASP_SFW_ALG_PROMOTION_FAILED
System Log Message ALG promotion failed. Stateful firewall application sfw-application-name conflicts with
NAT application nat-application-name or conflicts with QoS application; request creation
of discard flow
Description A matching application-level gateway protocol (ALG) was found from both the indicated
stateful firewall rule and either the indicated Network Address Translation (NAT) rule
or a quality-of-service (QoS) rule, but the two ALGs were not at the same level.
Type Event: This message reports an event, not an error
Severity critical
Facility LOG_PFE
Action Resolve the conflicting application-protocol matching conditions in the rules at the [edit
services stateful-firewall] hierarchy level and either the [edit services cos] (for QoS rules)
or [edit services nat] (for NAT rules) hierarchy level.
ASP_SFW_APP_MSG_TOO_LONG
System Log Message syslog-prefix error-code: proto protocol-id (protocol-name),
source-interface-nameseparatorsource-address:source-port ->
destination-addressdestination-port, event-type
Description The stateful firewall discarded the Transmission Control Protocol (TCP) packet with the
indicated characteristics, because the packet was so large that it exhausted memory
resources. The packet contained the indicated information about its protocol (numerical
identifier and name), source (logical interface name, IP address, and port number), and
destination (IP address and port number).
Type Event: This message reports an event, not an error
Severity notice
Facility LOG_PFE
87Copyright © 2010, Juniper Networks, Inc.
Chapter 9: ASP System Log Messages

Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Specifications

General

Brand	Juniper
Model	JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010
Category	Software
Language	English