Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 User Manual

Action Contact your technical support representative.
BOOTPD_NO_CONFIG
System Log Message No configuration file 'filename', using defaults
Description The boot parameter process (tnp.bootpd) could not open the indicated configuration
file, so it initialized using default settings defined at compile time.
Type Event: This message reports an event, not an error
Severity notice
Facility ANY
BOOTPD_PARSE_ERR
System Log Message filename: return-value parse errors on SIGHUP
Description There was an error in the configuration file for the boot parameter process (tnp.bootpd),
so it initialized using default settings defined at compile time.
Type Error: An error occurred
Severity error
Facility ANY
Action Correct the configuration file.
BOOTPD_REPARSE
System Log Message Reparsing configuration file 'filename'
Description The boot parameter process (tnp.bootpd) reparsed the indicated configuration file.
Type Event: This message reports an event, not an error
Severity info
Facility ANY
BOOTPD_SELECT_ERR
System Log Message select: error-message
Description The boot parameter process (tnp.bootpd) issued the select() system call, which returned
the indicated error message.
Type Error: An error occurred
Severity warning
Facility ANY
Action Contact your technical support representative.
127Copyright © 2010, Juniper Networks, Inc.
Chapter 16: BOOTPD System Log Messages

Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Specifications

General

Brand	Juniper
Model	JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010
Category	Software
Language	English