CHASSISD_FASIC_CONFIG_COMPLETE
System Log Message Fchip: configuration already completed
Description The chassis process (chassisd) detected an attempt to configure an F chip on a Control
Board (CB) when configuration was already complete.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
CHASSISD_FASIC_FTOKEN_ERROR
System Log Message Fchip (CB control-board-slot, ID fchip-id): ftoken overflow/underflow set (data) at address
Description The chassis process (chassisd) detected an underflow or overflow error on the indicated
F chip on the indicated Control Board (CB).
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
Action Contact your technical support representative.
CHASSISD_FASIC_FTOKEN_INIT_ERROR
System Log Message Fchip (CB control-board-slot, ID fchip-id): f8chip_ftoken_init() stuck in ftoken loop,
addr=address, data=data
Description The chassis process (chassisd) encountered an error while initializing memory at the
indicated address for the indicated F chip on the indicated Control Board (CB).
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
Action Contact your technical support representative.
CHASSISD_FASIC_HSL_CONFIG_ERROR
System Log Message Fchip (CB control-board-slot, ID fchip-id): HSL configuration failed (error error-message)
Description The chassis process (chassisd) could not configure high speed links (HSL) for the
indicated F chip on the indicated Control Board (CB).
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
Copyright © 2010, Juniper Networks, Inc.142
Junos 10.3 System Log Messages Reference
To Next Page
Loading...