CHASSISD_FASIC_RESET_ERROR
System Log Message Fchip (CB control-board-slot, ID fchip-id): reset failed
Description The chassis process (chassisd) could not reset the indicated F chip on the indicated
Control Board (CB).
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
Action Contact your technical support representative.
CHASSISD_FASIC_SRAM_ERROR
System Log Message Fchip (CB control-board-slot, ID fchip-id): SRAM fuse did not initialize
Description The chassis process (chassisd) detected that static RAM (SRAM) did not initialize properly
for the indicated F chip on the indicated Control Board (CB).
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
CHASSISD_FASIC_VERSION_ERROR
System Log Message Fchip (CB control-board-slot, ID fchip-id): part number part-number and version version
were invalid
Description The indicated part number and version detected for the indicated F chip on the indicated
Control Board (CB) were not valid values.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
CHASSISD_FCHIP_CONFIG_COMPLETE
System Log Message Fchip: configuration already completed
Description The chassis process (chassisd) detected an attempt to configure an F chip when
configuration was already complete.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
145Copyright © 2010, Juniper Networks, Inc.
Chapter 18: CHASSISD System Log Messages
To Next Page
Loading...