EasyManua.ls Logo

Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010

Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010
748 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Severity error
Facility LOG_DAEMON
Action Contact your technical support representative.
CHASSISD_FM_ERROR_SIB_L_HSR_TXP
System Log Message FM: error-message on LCC:lcc FPCfpc-slot_pfe link connected by
ST-SIB-Lfrom-lcc-sib_fchip-id_s-port_FBfiber-bundle to F13SIBto-sfc-sib
Description In a Tx-Plus routing matrix, packets traverse both electrical and optical media as they
travel between the Switch Interface Boards (SIBs) in the T1600 routing nodes (called
ST-SIB-Ls) and the SIBs in the TX Matrix Plus platform (called F13SIBs and F2S-SIBs).
The chassis process (chassisd) on the routing node that houses the indicated ST-SIB-L
detected an error in the electrical path between the indicated ports on the SIB-L and the
corresponding F13SIB.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
Action Contact your technical support representative.
CHASSISD_FM_ERROR_SIB_L_MISMATCH
System Log Message FM: fiber cable from SIB-L#sib-slot possibly connected to wrong SIB-S
Description In a routing matrix, the fiber-optic cable between each Switch Interface Board in a T640
routing node (called a SIB-L) must connect to a specific SIB port on the TX Matrix platform
(called a SIB-S). The cable originating at the indicated SIB-L was possibly plugged into
the wrong SIB-S port or wrong SIB-S.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
Action Contact your technical support representative.
CHASSISD_FM_ERROR_SIB_L_VC_PWR
System Log Message FM: High power difference at LCC lcc SIB_Lsib-slot_FBfiber-bundle VCSEL vcsel Channel
vcsel-channel connected to F13SIBfrom-sfc-sib
Description In a Tx-Plus routing matrix, packets traverse both electrical and optical media as they
travel between the Switch Interface Boards (SIBs) in the T1600 routing nodes (called
ST-SIB-Ls) and the SIBs in the TX Matrix Plus platform (called F13SIBs and F2S-SIBs).
The chassis process (chassisd) on the routing node that houses the indicated ST-SIB-L
detected higher than configured receive power levels on the indicated fiber-bundles
connected to the indicated LCC ST-SIB-L.
159Copyright © 2010, Juniper Networks, Inc.
Chapter 18: CHASSISD System Log Messages

Table of Contents

Related product manuals