Facility LOG_DAEMON
CHASSISD_HSR_FIFO_ERROR
System Log Message function-name: FIFO read failed for HSR identifier
Description A first in, first out (FIFO) read error occurred during execution of the indicated routine on
the indicated high-speed receiver (HSR).
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
CHASSISD_I2CS_READBACK_ERROR
System Log Message Readback error from I2C slave for fru-name fru-slot ([0xi2cs-address, 0xoffset] ->
0xerror-code)
Description The chassis process (chassisd) could not read back information from the I2C slave (I2CS)
about the indicated component (field-replaceable unit, or FRU).
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
Cause The probable cause is hardware error.
Action Contact your technical support representative.
CHASSISD_I2C_BAD_IDEEPROM_FORMAT
System Log Message Invalid IDEEPROM format for fru-name
Description The chassis process (chassisd) determined that the ID EEPROM format specified for the
indicated type of hardware component (field-replaceable unit, or FRU) is not valid for
it.
Type Error: An error occurred
Severity critical
Facility LOG_DAEMON
Action Contact your technical support representative.
CHASSISD_I2C_FIC_PRESENCE_READ
System Log Message function-name: fru-name unable to get presence masks (error-message)
Description The chassis process (chassisd) could not read I2C data with presence information about
the indicated component (field-replaceable unit, or FRU).
Copyright © 2010, Juniper Networks, Inc.170
Junos 10.3 System Log Messages Reference
To Next Page
Loading...