Description The chassis process (chassisd) could not perform the indicated I/O operation on the I2C
data for the indicated component (field-replaceable unit, or FRU).
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
Action Contact your technical support representative.
CHASSISD_I2C_MIDPLANE_CORRUPT
System Log Message Corruption on midplane ID EEPROM (ID: 0xassembly-id, MAC address: 0xmac-address,
0xversion)
Description The chassis process (chassisd) found corrupted information when it tried to verify the
parameters of the midplane's I2C ID EEPROM.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
Action Contact your technical support representative.
CHASSISD_I2C_RANGE_ERROR
System Log Message function-name: requested offset was out of range (offset offset + nbytes count > 256)
Description The indicated offset, which is greater than 256, was specified in a read request for an I2C
device.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
Cause No I2C device uses or has storage above an offset of 256.
Action Contact your technical support representative.
CHASSISD_I2C_READ_ERROR
System Log Message function-name: read error for group group-id at address 0xaddress, offset offset
Description The chassis process (chassisd) could not read I2C data from the indicated device.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
Copyright © 2010, Juniper Networks, Inc.172
Junos 10.3 System Log Messages Reference
To Next Page
Loading...