Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 User Manual

Facility LOG_DAEMON
Action Contact your technical support representative.
CHASSISD_MCHASSIS_SWITCH_WARNING
System Log Message CB settings on chassis-type old-index changed: switch is now 'value', chassis index is now
0xnew-index
Description A toggle switch on the back of the Control Board on each platform in a routing matrix is
set to 'M' (multichassis) on the T640 routing nodes and to 'S' (single-chassis) on the
TX Matrix platform. On a T640 routing node, the adjacent dial is set to the node's index
number in the routing matrix (0 through 3); on the TX Matrix platform it is set to 0. The
setting of the toggle switch, the dial, or both, changed to the indicated values on the
indicated platform. The new settings take effect when the routing matrix next reboots.
Type Event: This message reports an event, not an error
Severity warning
Facility LOG_DAEMON
Action If the changes were accidental, return the toggle and dial to the correct settings before
the next reboot. If the changes were intended, disconnect and move the cables on the
TX Matrix platform Switch Interface Board (SIB) to the row that corresponds to the T640
routing node's new index number.
CHASSISD_MCS_INTR_ERROR
System Log Message Received SIGUSR2 without any interrupts pending
Description The chassis process (chassisd) received the indicated interrupt signal. The signal normally
indicates that an event on the Miscellaneous Control Subsystem (MCS) requires servicing.
However, the chassisd process did not find such an event pending. This error does not
usually cause component failure.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
Action Contact your technical support representative.
CHASSISD_MGR_CONNECT
System Log Message function-name evSelectFD: initial pipe create aborted (errno error-code)
Description The chassis process (chassisd) could not to open a pipe for interprocess communication
(IPC) to a component (field-replaceable unit, or FRU).
Type Error: An error occurred
Severity error
Copyright © 2010, Juniper Networks, Inc.186
Junos 10.3 System Log Messages Reference

Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Specifications

General

Brand	Juniper
Model	JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010
Category	Software
Language	English