CHASSISD_SMB_INVALID_PS
System Log Message function-name: invalid power supply status code (0xstatus-code)
Description The chassis process (chassisd) could not set the status (enabled or disabled) for a power
supply, because it received the indicated power supply status code, which is invalid.
Type Error: An error occurred
Severity critical
Facility LOG_DAEMON
Action Contact your technical support representative.
CHASSISD_SMB_IOCTL_FAILURE
System Log Message function-name: 'operation' ioctl failed on system management bus (address
0xmemory-address, cmd 0xcommand)
Description The indicated ioctl() operation failed at the indicated address on the system management
bus (SMB).
Type Error: An error occurred
Severity critical
Facility LOG_DAEMON
Action Contact your technical support representative.
CHASSISD_SMB_READ_FAILURE
System Log Message function-name: read() failed on system management bus (address 0xmemory-address)
Description A read() operation failed at the indicated address on the system management bus (SMB).
Type Error: An error occurred
Severity critical
Facility LOG_DAEMON
Action Contact your technical support representative.
CHASSISD_SNMP_TRAP1
System Log Message SNMP trap generated: trap (argument1 value1)
Description The chassisd process (chassisd) generated the indicated simple network management
protocol (snmp) trap with the indicated value.
Type Event: This message reports an event, not an error
Severity notice
203Copyright © 2010, Juniper Networks, Inc.
Chapter 18: CHASSISD System Log Messages
To Next Page
Loading...