Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 User Manual

Description The indicated PIC is either not supported on this routing platform or is not supported by
the installed version of the chassis process (chassisd) software. The chassisd process
did not bring the PIC online.
Type Error: An error occurred
Severity warning
Facility LOG_DAEMON
Action Contact your technical support representative.
CHASSISD_UNSUPPORTED_PIC_MODE
System Log Message Application mode mode is not supported for PIC pic-slot in FPC fpc-slot
Description The indicated PIC does not support the indicated application mode configured for it.
Type Event: This message reports an event, not an error
Severity warning
Facility LOG_DAEMON
Action Check which application modes are supported for the PIC.
CHASSISD_UNSUPPORTED_SIB
System Log Message SIB with assembly ID assembly-id is not supported
Description The chassis process (chassisd) detected the presence of a new Switch Interface Board
(SIB) with the indicated assembly ID. The SIB remains offline, because it is not a supported
type.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
Action Contact your technical support representative.
CHASSISD_VERSION_MISMATCH
System Log Message Version mismatch: chassisd message version expected-value fru-name fru-slot message
version received-value local IPC version local-ipc-version remote IPC version
remote-ipc-version
Description As a component (field-replaceable unit, or FRU) comes online, the chassis process
(chassisd) verifies that the FRU's revision level or version is supported. The revision level
of the indicated FRU was unsupported or otherwise invalid.
Type Error: An error occurred
Severity error
209Copyright © 2010, Juniper Networks, Inc.
Chapter 18: CHASSISD System Log Messages

Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Specifications

General

Brand	Juniper
Model	JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010
Category	Software
Language	English