Type Error: An error occurred
Severity error
Facility LOG_DAEMON
Cause The interface is not housed on one of the PIC types that support large delay buffer.
Action Remove the large delay buffer configuration from the interface.
COSD_MALLOC_FAILED
System Log Message malloc failed: error-message
Description The class-of-service (CoS) process (cosd) could not dynamically allocate memory for
the indicated reason.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
Cause A software bug caused a memory leak or the Routing Engine did not have sufficient
memory.
Action Contact your technical support representative.
COSD_MPLS_DSCP_CLASS_NO_SUPPORT
System Log Message Cannot support MPLS DSCP classifier on ifl interface-name
Description The MPLS Differentiated Services code point (DSCP) classifier is only supported on I-Chip
based Flexible PIC Concentrators (FPCs). It is not supported on Q2 PICs.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
Action Remove the MPLS DSCP classifier configuration from the logical interface.
COSD_MULTILINK_CLASS_CONFLICT
System Log Message Fragmentation map fragmentation-map for wildcard wildcard-interface-name specified
multilink class class-name for queue queue-number on interface interface-name, which
exceeds configured limit of limit
Description The indicated fragmentation map is normally applied to interfaces that match the
indicated wildcard, and specifies the indicated multilink class setting for queues on those
interfaces. The class-of-service (CoS) process (cosd) did not apply the fragmentation
map to the indicated interface, even though it matches the wildcard, because the setting
in the map exceeds the indicated class limit, which is configured on the interface itself.
Copyright © 2010, Juniper Networks, Inc.220
Junos 10.3 System Log Messages Reference
To Next Page
Loading...
Need help?
General
