Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 User Manual

Action Either limit the number of rate-limited schedulers in this scheduler map to the allowed
maximum for this PIC and interface type or check the allowed priority for rate-limited
queues
COSD_RATE_LIMIT_NOT_SUPPORTED
System Log Message Unable to apply scheduler map scheduler-map to interface interface-name because it
does not support rate limiting
Description The class-of-service (CoS) process (cosd) did not apply the indicated scheduler map
to the indicated interface, because a scheduler named in the scheduler map is configured
for rate limiting. The interface is housed in a type of PIC that does not support rate limiting.
In terms of configuration, the 'rate-limit' statement is included in the scheduler definition
at the [edit class-of-service schedulers <scheduler-name> transmit-rate <rate> | percent
<percentage>] hierarchy level. The scheduler is included in the scheduler map applied
to the interface.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
Action Remove the 'rate-limit' statement from the scheduler in the scheduler map applied to
the interface.
COSD_REWRITE_RULE_LIMIT_EXCEEDED
System Log Message Number of rewrite rules applied to interface interface-name exceeds limit
(maximum-value)
Description The class-of-service (CoS) process (cosd) determined that the number of rewrite rules
applied to the indicated interface exceeds the indicated limit for the interface. In terms
of configuration, too many rewrite rules are included at the [edit class-of-service interfaces
<interface-name> unit <logical-unit-number> rewrite-rules] hierarchy level.
Type Error: An error occurred
Severity error
Facility ANY
Action Remove rewrite rules from the configuration for the interface.
COSD_RL_IFL_NEEDS_SHAPING
System Log Message "rate-limit" configured in scheduler-map, but ifl interface-name does not have output
shaper configured. It will use the ifd-shaping rate/ifd-transmit rate for implementation
of rate-limit.
Description The 'rate-limit' statement is configured in one or more schedulers that are part of the
indicated scheduler map. In order to apply this scheduler map to the indicated interface,
Copyright © 2010, Juniper Networks, Inc.222
Junos 10.3 System Log Messages Reference

Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Specifications

General

Brand	Juniper
Model	JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010
Category	Software
Language	English