Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 User Manual

Severity error
Facility LOG_DAEMON
Cause An internal software failure occurred.
Action Contact your technical support representative.
MIB2D_IF_FLAPPING_MISSING
System Log Message function-name: interface flapping missing: ifname(interface-name) old
if_anydown_flaps(old-value) if_anydown_flaps(new-value)
Description The MIB II process (mib2d) is blocked on the kernel for synchronous message. If there is
an interface flap (down and then back up again) in the time mib2d is blocked in the kernel,
mib2d will miss asychronous messages from the kernel about state changes.
Type Event: This message reports an event, not an error
Severity notice
Facility LOG_DAEMON
MIB2D_KVM_FAILURE
System Log Message function-name: reason: error-message
Description A call to the indicated function in the kernel virtual memory library failed.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
Cause An internal software failure occurred.
Action Contact your technical support representative.
MIB2D_PMON_OVERLOAD_CLEARED_TRAP
System Log Message Overload name: overload-name, interface: interface-name
Description The MIB II process (mib2d) generated a jnxPMonOverloadCleared trap when it detected
the clearing of an overload condition on the indicated monitoring services interface.
Type Event: This message reports an event, not an error
Severity warning
Facility LOG_DAEMON
MIB2D_PMON_OVERLOAD_SET_TRAP
System Log Message Overload name: overload-name, interface: interface-name
445Copyright © 2010, Juniper Networks, Inc.
Chapter 59: MIB2D System Log Messages

Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Specifications

General

Brand	Juniper
Model	JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010
Category	Software
Language	English