Facility ANY
Action Modify the configuration statement to use a valid value.
RPD_AMT_CFG_LOC_ADDR_MCAST
System Log Message Local-address route-prefix cannot be a multicast address
Description A multicast address cannot be configured as the local-address.
Type Event: This message reports an event, not an error
Severity warning
Facility ANY
Action Modify the configuration statement to use a valid value.
RPD_AMT_CFG_PREFIX_LEN_SHORT
System Log Message Prefix length prefix-length is too short for prefix route-prefix
Description The prefix length for the indicated prefix is too short and it has a non-zero host portion.
Excess host bits will be ignored.
Type Event: This message reports an event, not an error
Severity warning
Facility ANY
RPD_AMT_CFG_RELAY_INVALID
System Log Message Invalid relay information is configured
Description Invalid relay configuration was encountered while parsing AMT configuration.
Type Event: This message reports an event, not an error
Severity warning
Facility ANY
Action Modify the configuration statement to use a valid value.
RPD_AMT_RELAY_DISCOVERY
System Log Message AMT relay discovery message from gateway destination-address port destination-port
at time
Description AMT relay discovery event.
Type Event: This message reports an event, not an error
Severity info
Facility ANY
499Copyright © 2010, Juniper Networks, Inc.
Chapter 73: RPD System Log Messages
To Next Page
Loading...