Description The auto-bandwidth adjustment for the indicated Multiprotocol Label Switching (MPLS)
label-switched path (LSP) already in progress, ignoring new trigger.
Type Event: This message reports an event, not an error
Severity notice
Facility LOG_DAEMON
RPD_MPLS_LSP_BANDWIDTH_CHANGE
System Log Message MPLS LSP lsp-name bandwidth changed, lsp bandwidth bandwidth bps
Description The bandwidth associated with the indicated Multiprotocol Label Switching (MPLS)
label-switched path (LSP) changed.
Type Event: This message reports an event, not an error
Severity warning
Facility LOG_DAEMON
RPD_MPLS_LSP_CHANGE
System Log Message MPLS LSP lsp-name change on path-type(pathname) Route lsp-rro lsp bandwidth
bandwidth bps
Description The indicated Multiprotocol Label Switching (MPLS) label-switched path (LSP) was
rerouted and its Record Route Object (RRO) changed.
Type Event: This message reports an event, not an error
Severity warning
Facility LOG_DAEMON
RPD_MPLS_LSP_DOWN
System Log Message MPLS LSP lsp-name down on path-type(pathname)
Description The indicated Multiprotocol Label Switching (MPLS) label-switched path (LSP) went
down and could not be used to send traffic.
Type Event: This message reports an event, not an error
Severity warning
Facility LOG_DAEMON
RPD_MPLS_LSP_SWITCH
System Log Message MPLS LSP lsp-name switch from old-path-type(old-pathname) to
new-path-type(new-pathname), Route lsp-rro: reason lsp bandwidth bandwidth bps
Description The indicated Multiprotocol Label Switching (MPLS) label-switched path (LSP) switched
from primary path to secondary path or vice versa.
Copyright © 2010, Juniper Networks, Inc.538
Junos 10.3 System Log Messages Reference