Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 User Manual

Action Contact your technical support representative.
RPD_MPLS_OAM_WRITE_ERROR
System Log Message Unable to write to pipe to MPLS OAM process: (error-message)
Description The routing protocol process (rpd) could not write a message on the write pipe to the
MPLS Operation, Administration, and Maintenance process (mplsoamd).
Type Error: An error occurred
Severity info
Facility LOG_DAEMON
Action Contact your technical support representative.
RPD_MPLS_PATH_BANDWIDTH_CHANGE
System Log Message MPLS path pathname (lsp lsp-name) bandwidth changed, path bandwidth bandwidth
bps
Description The bandwidth associated with the indicated Multiprotocol Label Switching (MPLS)
path changed.
Type Event: This message reports an event, not an error
Severity warning
Facility LOG_DAEMON
RPD_MPLS_PATH_BFD_DOWN
System Log Message BFD session for MPLS path pathname went down on LSP lsp-name
Description The routing protocol process (rpd) determined that the Bidirectional Forwarding Detection
(BFD) protocol session for the indicated Multiprotocol Label Switching (MPLS) path
terminated on the indicated label-switched path (LSP).
Type Event: This message reports an event, not an error
Severity notice
Facility LOG_DAEMON
RPD_MPLS_PATH_BFD_UP
System Log Message BFD session for MPLS path pathname came up on LSP lsp-name
Description The routing protocol process (rpd) determined that the Bidirectional Forwarding Detection
(BFD) protocol session for the the indicated Multiprotocol Label Switching (MPLS) path
came up on the indicated label-switched path (LSP).
Type Event: This message reports an event, not an error
Severity notice
Copyright © 2010, Juniper Networks, Inc.540
Junos 10.3 System Log Messages Reference

Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Specifications

General

Brand	Juniper
Model	JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010
Category	Software
Language	English