Facility LOG_DAEMON
RPD_MPLS_PATH_BW_NOT_AVAILABLE
System Log Message Unable to satisfy bandwidth configured for MPLS path pathname on LSP lsp-name
Description The bandwidth setting for the indicated Multiprotocol Label Switching (MPLS) path and
label-switched path (LSP) was changed recently, but attempts to apply the new setting
failed. The LSP continued to use the previous amount of bandwidth.
Type Event: This message reports an event, not an error
Severity warning
Facility LOG_DAEMON
Action Determine the reason that the bandwidth could not change and make the necessary
changes to the software configuration, hardware configuration, or both.
RPD_MPLS_PATH_DOWN
System Log Message MPLS path pathname down on LSP lsp-name
Description The indicated Multiprotocol Label Switching (MPLS) path went down on the indicated
label-switched path (LSP).
Type Event: This message reports an event, not an error
Severity warning
Facility LOG_DAEMON
RPD_MPLS_PATH_PING_DOWN
System Log Message LSP ping failure occured for MPLS path pathname on LSP lsp-name
Description The routing protocol process (rpd) determined that the LSP ping returned error for the
indicated Multiprotocol Label Switching (MPLS) path terminated on the indicated
label-switched path (LSP).
Type Event: This message reports an event, not an error
Severity notice
Facility LOG_DAEMON
RPD_MPLS_PATH_UP
System Log Message MPLS path pathname up on LSP lsp-name path bandwidth bandwidth bps
Description The indicated Multiprotocol Label Switching (MPLS) path came up on the indicated
label-switched path (LSP).
Type Event: This message reports an event, not an error
Severity warning
541Copyright © 2010, Juniper Networks, Inc.
Chapter 73: RPD System Log Messages