Facility LOG_DAEMON
RPD_MPLS_TABLE_ROUTE_ERROR
System Log Message Unable to add route in table table-name for label mpls-label pointing to next-table-name
Description There was a failure in adding a Multiprotocol Label Switching (MPLS) route pointing to
another MPLS routing table
Type Event: This message reports an event, not an error
Severity notice
Facility LOG_DAEMON
RPD_MSDP_CFG_SA_LIMITS_CONFLICT
System Log Message Threshold value threshold must be less than or equal to maximum value maximum-value.
Setting threshold to maximum
Description The MSDP active-source-limit threshold is either undefined or exceeds the maximum
value. Threshold will be set to maximum.
Type Event: This message reports an event, not an error
Severity warning
Facility ANY
Action Consider modifying the MSDP active-source-limit configurations.
RPD_MSDP_CFG_SRC_INVALID
System Log Message argument is an invalid source address
Description The indicated MSDP source is configured with an invalid address
Type Event: This message reports an event, not an error
Severity warning
Facility ANY
Action Modify the configuration statement to use a valid value.
RPD_MSDP_PEER_DOWN
System Log Message MSDP peer peer-address peer-group peer-group out of Established state
Description The indicated MSDP peer left the Established state. The routing protocol process (rpd)
deleted all active sources learned from the peer and will no longer send 'Source Active'
messages to it.
Type Event: This message reports an event, not an error
Severity notice
Copyright © 2010, Juniper Networks, Inc.542
Junos 10.3 System Log Messages Reference