Description An OSPF adjacency with the indicated neighboring router was terminated. The local
router no longer exchanges routing information with, or directs traffic to, the neighboring
router.
Type Event: This message reports an event, not an error
Severity notice
Facility LOG_DAEMON
RPD_OSPF_NBRUP
System Log Message OSPF neighbor neighbor-address (realm realm-name interface-name area area-idi) state
changed from old-state to new-state due to event-name (event reason: reason)
Description An OSPF adjacency was established with the indicated neighboring router. The local
router can now exchange information with it.
Type Event: This message reports an event, not an error
Severity info
Facility LOG_DAEMON
RPD_OSPF_OVERLOAD
System Log Message OSPF instance instance topology topology is going into overload state: number of export
prefixes (count) exceeded maximum allowed (maximum-value)
Description The indicated topology in the indicated OSPF instance became overloaded and will
remain in that state until an administrator intervenes.
Type Error: An error occurred
Severity warning
Facility LOG_DAEMON
Cause The number of export prefixes exceeded the configured limit.
Action Unconfigure or modify export policies that inject a large number of routes.
RPD_OS_MEMHIGH
System Log Message Using size KB of memory, percentage-value percent of available
Description The routing protocol process (rpd) is using the indicated amount and percentage of
Routing Engine memory, which is considered excessive.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
Copyright © 2010, Juniper Networks, Inc.546
Junos 10.3 System Log Messages Reference
To Next Page
Loading...