Description The routing protocol process (rpd) started.
Type Event: This message reports an event, not an error
Severity info
Facility LOG_DAEMON
RPD_SYSTEM
System Log Message reason: error-message
Description A system call made by the routing protocol process (rpd) failed.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
Cause It is possible that the kernel lacked the resources to fulfill the request. The rpd process
will recover.
RPD_TASK_BEGIN
System Log Message Commencing routing updates, version rpd-version, built date by builder
Description The routing protocol process (rpd) started.
Type Event: This message reports an event, not an error
Severity notice
Facility LOG_DAEMON
RPD_TASK_CHILDKILLED
System Log Message task-name terminated by SIGsignal-namecore-dump-status
Description While a child process of the routing protocol process (rpd) was performing the indicated
operation, it terminated in response to the indicated signal.
Type Event: This message reports an event, not an error
Severity error
Facility LOG_DAEMON
RPD_TASK_CHILDSTOPPED
System Log Message task-name stopped by SIGsignal-name
Description While a child process of the routing protocol process (rpd) was performing the indicated
operation, it stopped in response to the indicated signal.
Type Event: This message reports an event, not an error
565Copyright © 2010, Juniper Networks, Inc.
Chapter 73: RPD System Log Messages
To Next Page
Loading...