Cause An internal software failure occurred.
Action Contact your technical support representative.
UI_READ_TIMEOUT
System Log Message Timeout on read of peer 'peer-name'
Description When communicating with other JUNOS processes running on the routing platform
(referred to as peers), the management process (mgd) waits only a defined period for
responses to arrive. The timeout period passed for the indicated process.
Type Event: This message reports an event, not an error
Severity notice
Facility ANY
UI_REBOOT_EVENT
System Log Message System halt-reboot by 'username'
Description The indicated software process restarted as requested by the indicated user.
Type Event: This message reports an event, not an error
Severity warning
Facility LOG_AUTH
UI_RESCUE_OPERATION
System Log Message Committing rescue configuration because CONFIG button was pressed
Description The management process (mgd) began a commit operation to activate the rescue
configuration, because the CONFIG button on the chassis was pressed.
Type Event: This message reports an event, not an error
Severity notice
Facility LOG_AUTH
UI_RESTART_EVENT
System Log Message User 'username' restarting daemon 'process-name'description
Description The indicated software process restarted as requested by the indicated user.
Type Event: This message reports an event, not an error
Severity warning
Facility LOG_AUTH
653Copyright © 2010, Juniper Networks, Inc.
Chapter 88: UI System Log Messages
To Next Page
Loading...