Error text (continuation)
Overcurrent at the brake output
ERROR Limit Switch Forward
positive (hardware) limit switch released
ERROR Limit Switch Reverse
negative (hardware) limit switch released
ERROR Override Limit Switch For-
ward
positive (hardware) limit switch override out of the
range of hm19
ERROR Override Limit Switch Re-
verse
negative (hardware) limit switch override out of the
range of hm20
Ether both (hardware) limit switches released or
one (hardware) limit switch released and only the
actual direction of rotation corresponds to the limit
switch direction
ERROR at encoder type change
Incompatible encoder interface and drive software
versions
ERROR enc.intf.fast comm.
Communication error control board-encoder inter-
face
Encoder interface in initialisation routine
Hardware defect or incorrect
setting of the encoder parame-
ters (type, increments per revo-
lution, etc.)
Initialisation encoder A is running
Initialisation encoder B is running
No encoder type is selected in ec16 in a mode that
requires an encoder
pn72 overspeed level (EMF) has been exceeded
Serial number read by the
encoder is not equal to the
stored serial number (ec48 !=
ec49)
Overcurrent at digital output 1
Overcurrent at digital output 2
Overcurrent at digital output 3
Overcurrent at digital output 4
ERROR overcurrent encoder
Overcurrent at encoder interface
Overcurrent at 24V outputs of the control terminal
block
The maximum output frequency de120 has been
exceeded. (599Hz)
reset E. overheat intern CB
Overtemperature control board decreased
ERROR overheat internal CB
Overtemperature internal control board
Maximum available time between the occurrence of
an overtemperature error and the modulation
switching off has expired
24V supply has dropped to a value lower than 18V
To Next Page
Loading...
Need help?
General
