2.2
Connecting the Transceiver to a PC by Bluetooth
To write the configuration data to the transceiver or to read the configuration data from the transceiver by using Bluetooth
communication, “Bluetooth SPP” needs to be selected from Communication Method of COM port and a Bluetooth-
compatible device (the transceiver) to be written with the configuration data needs to be selected in Device List.
Configuration using KPG-D1/ D1N
0
Configuring Communication Method ( Setup > COM port)
0
Selecting a Bluetooth-compatible device (the transceiver) in Device List ( Setup > COM port > Bluetooth SPP)
2.3
Writing the Configuration Data to the Transceiver
Clicking the “Write” button in Program
of KPG-D1/ D1N displays Write Data to the Transceiver. Clicking the “Write” button
of Write Data to the Transceiver enters FPU Programming Mode and starts writing the configuration data to the transceiver.
Figure 2-2 Write Data to the Transceiver
Note
The transceiver behaves as follows according to the configuration in Write Data to the Transceiver:
0
Clicking on Zeroize and writing deletes the Encryption Key configuration in the SCM.
0
Clicking on Time Adjustment and
writing automatically configures the transceiver to the time configured in a PC. Refer
to “ADJUSTING THE TIME ON THE TRANSCEIVER” for the operations to manually adjust the time of the transceiver
after writing the configuration data.
0
Clicking on Audio/GPS Data Erase (Internal Memory) and writing deletes the audio data and GPS data stored on the
transceiver.
0
Clicking on DFA Data Erase and writing deletes the Direct Frequency Assignment information stored on the transceiver.
0
Clicking on Consecutive Write and writing does not close Write Data to the Transceiver even when the writing
completes, and various IDs can be changed and written in other transceiver.
0
Clicking on ID (Own) Overwrite and writing overwrites various ID data on the transceiver by the ID data configured by
KPG-D1/ D1N. Clicking off ID (Own) Overwrite and writing can write configuration data on the transceiver without
overwriting various IDs configured in the transceiver.
2 GETTING STARTED
2.2 Connecting the Transceiver to a PC by Bluetooth
Common FUNC (K, F)/Ver 2.20 22
CONTENTS INDEX
To Next Page
Loading...
Need help?
General
