Safety Summary
The following general safety precautions must be observed during all phases of operation,
service, and repair of this instrument. Failure to comply with these precautions or with specific
warnings elsewhere in this manual may impair the protections provided by the instrument. In
addition, it violates safety standards of design, manufacture, and intended use of the
instrument. Keysight Technologies assumes no liability for customer’s failure to comply with
these requirements.
For the Lithium-ion battery, also see “Safety Precautions for Lithium-ion Battery (Keysight part
number B2980-90100).”
Product manuals may also be available on the Web. Go to www.keysight.com and type the
product model number in the Search field at the top of the page.
Do not use this instrument in any manner not specified by the manufacturer. The protective
features of this instrument may be impaired if it is used in a manner not specified in the
operation instructions.
This instrument is an INDOOR USE product.
This instrument complies with OVERVOLTAGE CATEGORY II for mains input and POLLUTION
DEGREE 2 defined in IEC 61010-1.
If an instrument is marked CAT I (IEC Measurement Category I), or it is not marked with a
measurement category, its measurement terminals must not be connected to line-voltage
mains.
Safety of any system incorporating the equipment is the responsibility of the assembler of the
system.
Hazardous voltage of up to the instrument’s maximum voltage may appear at
High terminal if Interlock terminal is closed. Open the Interlock terminal when
the High terminal is accessible. Voltage applied to the terminals will be limited
up to 21 V.
Do not work the interlock function intentionally in order to bring the output
voltage to the safe level. While the high voltage indicator is lit, the dangerous
voltage by the output voltage or the residual charge appears on the
measurement terminal.
To Next Page
Loading...
Need help?
General
