bizhub C652/C552 7-9
7.1 System Settings
7
Finisher Adjustment Adjust the staple, folding, and punch position of the finisher.
This button appears only when the finisher is installed.
d Reference
Create a sample in advance, and then adjust them while
checking the sample.
Center Staple Position p. 7-12
Half-Fold Position p. 7-13
Tri-Fold Position Adjustment p. 7-13
Punch Vertical Position Adjust-
ment
p. 7-14
Punch Horizontal Position Ad-
justment
p. 7-14
Finisher Adjustment Punch Regist Loop Size Adjust-
ment
p. 7-15
Punch Edge Sensor Adjustment p. 7-15
Density Adjustment Correct the toner amount to be used by color depending on the paper
type.
• To correct the toner amount to be used in the black print mode, press
[Black Image Density].
Image Stabilization Image Stabilization Only Press the [Start] key to stabilize imag-
es.
Pressing the [Image Stabilization Only]
button executes normal image stabili-
zation.
If a good result was not achieved after
the [Image Stabilization Only] button
was pressed, execute [Initialize + Im-
age Stabilization].
Image Stabilization Setting Select the image stabilization setting.
Selecting [Color Priority] stabilizes
color during warm-up when absolute
humidity change is detected during
the warm-up.
Selecting [Black & White Priority] exe-
cutes monochrome stabilization dur-
ing warm-up when absolute humidity
change is detected during the warm-
up, and then stabilizes color before
performing color print.
Paper Separation Adjust-
ment
Adjust the paper position where the two sides are separated for 2-sided
print.
Color Registration Adjust Correct color shifts if they are detected in the print result.
For details, refer to page 7-16.
Gradation Adjustment Adjust irregular gradation levels of print images.
For details, refer to page 7-17.
Image Stabilization Only Stabilize the image by pressing the
[Start] key before performing grada-
tion adjustment.
Print This adjusts gradation either by priori-
tizing gradation or prioritizing resolu-
tion.
Copy This adjusts gradation for copy and
nonscreen.
Scanner Area Adjust the scan range of the scanner.
For details on displaying this item, contact your service representative.
ADF Adjustment Make adjustments for scanning images in the ADF.
For details on displaying this item, contact your service representative.
Settings
To Next Page
Loading...
