EasyManua.ls Logo

Konica Minolta C652 - Page 203

Konica Minolta C652
275 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
bizhub C652/C552 9-8
9.2 Troubleshooting table
9
Install toner cartridge (X) The indicated toner cartridge is
not installed correctly.
Reinstall each consumable and
replaceable part. Or contact your
service representative.
Set the toner cartridge, and
close all doors.
The indicated toner cartridge is
not installed correctly.
Reinstall each consumable and
replaceable part. Or contact your
service representative.
Install the waste toner box and
close all doors.
The waste toner box is not in-
stalled correctly.
Reinstall each consumable and
replaceable part. Or contact your
service representative.
Set Drum Unit and shut all doors The drum unit is not set correctly. Reinstall each consumable and
replaceable part. Or contact your
service representative.
Set Developing Unit and shut all
doors
The developing unit is not set
correctly.
Reinstall each consumable and
replaceable part. Or contact your
service representative.
Replenish paper. The indicated tray has run out of
paper.
Add paper. (p. 8-3)
Toner (X) is low. Please when in-
dicate.
The toner for the indicated color
is about to run out.
Prepare to replace the toner car-
tridge following the guidance
contained in your maintenance
agreement.
Install toner cartridge (X) The toner is about to run out. Replace the toner cartridge fol-
lowing the guidance contained in
your maintenance agreement.
Toner is depleted
Replace the toner cartridge fol-
lowing the guidance (explana-
tion).
Press the [Continue] button to
continue the operations.
Toner is depleted Replace the toner cartridge fol-
lowing the guidance contained in
your maintenance agreement.
No more staples.
Replace the staple cartridge, or
cancel stapling
The staples have run out. Replace the staple cartridge.
Misfeed detected.
Remove misfeed at circle.
Since a paper jam occurred, the
machine is unable to make cop-
ies.
Clear the jammed paper.
Empty hole-punch scrap box
To continue the job, disable
punching.
The hole-punch scrap box is full. Throw punch scraps away from
the hole-punch scrap box.
Reset the following number of
originals.
XX
After clearing a paper jam, it is
necessary to reload certain pag-
es of the original that have al-
ready been fed through the ADF.
Load the indicated original pages
into the ADF.
An internal error occurred. Open
and then close the lower front
door. If the trouble code ap-
pears again, contact your Serv-
ice Rep.
The machine malfunctioned and
is unable to make copies.
Take a remedy according to the
message displayed in the
screen. If the problem is not re-
solved or released, inform your
service representative of the
malfunction code displayed in
the screen.
An internal error occurred. Turn
the main switch OFF and ON. If
the trouble code appears again,
contact your Service Rep.
Malfunction detected.
Inform the service representa-
tive of the error code.
The machine malfunctioned and
is unable to make copies.
Inform your service representa-
tive of the code displayed in the
screen.
Clean the original glass on the
left with a glass cleaner. Contin-
uing using the machine in this
condition may cause lines to ap-
pear in the output.
The original glass is dirty. User the original glass cleaner to
clean it.
Message Cause Remedy

Table of Contents

Related product manuals