bizhub C652/C552 5-37
5.4 Application
5
d Reference
To set the zoom:
Press [Basic] ö [Zoom].
Settings
Margin Position Select an option from [Auto], [Left], [Top] and [Right].
When Auto is selected, the binding position is automatically set.
• This function automatically determines the binding position according to
the orientation of the loaded original. If the original length is 11-11/16inch
or less, a binding position along the long side of the paper is selected. If
the original length is more than 11-11/16inch, a binding position along
the short side of the paper is selected.
• The binding position is set on the upper or left-side end.
• Be sure to load the original so that its top side is placed in the back. If
the document is loaded in any other orientation, this setting fails.
Image Shift Adjust the image position according to the binding margin.
Change Back Shift Adjust the image position on the back side of the
paper in the 2-sided copy mode.
Adjust Value Configure the width of the binding margin (1/16 inch to 3/4 inch) with press-
ing [+] and [-]. When [None] is selected, the binding margin width is set to 0
inch.
Original Direction Select the orientation of the original loaded into the ADF or placed on the
original glass.
To Next Page
Loading...
