4-18
Basic Operation > Handling Destination
Checking and Editing Destinations
1
Display the screen.
Specify the destination.
2
Check and edit the destination.
Select [ ] to display a destination list.
• Select [ ] (information icon) to check the destination.
• Select [ ] (edit icon) to edit the destination.
• Select [ ] (delete icon) to remove the destination from the list
.
Recall
Recall is a function allowing you to send the last entered destination once again. When you want to send the image to
the same destination, select [Recall], and you can call the destination you sent on the destination list.
1
Select [Recall].
The destination you sent is displayed on the destination list.
2
Press the [Start] key.
Sending starts.
Specifying Destination (page 4-15)
When selecting [On] for Destination Check before Send, the confirmation screen appears
after pressing the [Start] key.
Recall (page 4-18)
When the last sending included E-mail destinations, they are also displayed. If necessary,
add or delete the destination.
Recall information is canceled in the following conditions.
- When you turn the power off
- When you send a next image (new recall information is registered)
- When you log out
To Next Page
Loading...
