Kyocera Taskalfa Pro 15000c - Send;Store; Email; Sending Job - Folder

15-39
Setting up from System Menu > Function Settings
Send/Store
[System Menu/Counter] key > [Function Settings] > [Send/Store]
Email
[System Menu/Counter] key > [Function Settings] > [Email]
Sending Job - Folder
[System Menu/Counter] key > [Function Settings] > [Sending Job - Folder]
Item Description
Default Screen Set the default screen displayed when you select the [Send] key.
Value: Destination, Address Book
Quick Setup Registration (Send) Quick Setup Registration (Send) (page 15-9)
Item Description
Email Settings SMTP (Email TX) Select whether to send E-mail using SMTP.
Value: Off, On
SMTP Server Name Enter the host name or IP address of the SMTP server.
SMTP Port Number Specify the port number to be used for SMTP.
The default port number is 21.
Value: 1 to 65535 (Port number)
Sender Address Specify the sender address for when the machine sends Emails,
such as the machine administrator, so that a reply or non-delivery
report will go to a person rather than to the machine. The sender
address must be entered correctly for SMTP authentication. The
maximum length of the sender address is 256 characters.
POP3 Select whether to receive E-mail using POP3.
Value: Off, On
Remote Printing
Remote Printing (page 15-43)
Item Description
FTP Settings Select whether to send documents using FTP. To use the FTP Client, set the protocol to
[On] for "Protocol Settings". The default port number is 21.
Value: Off, On, 1 to 65535 (Port number)
SMB Settings Select whether to send documents using SMB. To use the SMB Client, set the protocol to
[On] for "Protocol Settings". The default port number is 445.
Value: Off, On, 1 to 65535 (Port number)