6-17
Using Custom Paper > Setting from the Operation Panel
4
Measure the correction value for the trailing edge of the paper.
Check scale "MS2", and find the value of the location where the black lines and red lines align.
In the example below, the lines align at 0, so a correction value is not needed.
5
Enter the correction value.
1 [System Menu/Counter] key > [Device Settings] > [Paper Feeding] > "Cassette
Settings" [Cassette 1 (to 8) Settings] > [Manual] > "Adjustment Items" [Adjust Motor
Speed]
2 Enter the adjustment value for the leading edge of the paper found in step 3.
3 Enter the adjustment value for the trailing edge of the paper found in step 4.
4 [OK] > [Close]
The scale “MS2” may not be printed depending on the paper size used. In this case, you do
not have to enter the correction value for the trailing edge of the paper.
To Next Page
Loading...
