System controls
Chapter 2 - page 6
M-HE.002.1003
Key (G1) Milk data
Key (G2) Feed data
Key (G3) Conductivity data
The conductivity values displayed represent average values measured per quarter during milking. If the
discrepancy for a certain quarter in respect of the calculated value is much larger than allowed, this value is flashed
on the screen.
MILK ###
O/I actual milk yield (kg): this screen is displayed as standard if the yield
exceeds 2,5 kg (5.5 lb.).
MILKT ###
O milk test value: the minimum milk yield calculated by X-pert, which is
expected from the cow.
SEPMLK ##
O/I number of milkings (including the present one) that the milk should
be separated.
MLKSP ##
O/I average milking speed (kg/min.).
MAXSPD ##
O/I maximum measured milking speed.
TIME ###
O/I not applicable.
COLOST x
O colostrum milk (yes or no).
FEEDM ###
O/I not of interest for the milking robot
quantity (kg) of feed calculated for the present milking in the milking
parlour.
FDNR ##
O/I feed number.
FEED ###
O day total feed.
BAL ###
O balance feed quantity (kg) calculated for the present milking.
FDPER ##
O present feed period.
NFDCY ##
O number of feed cycles the controller did not provide feed.
RF ####
O conductivity value RF quarter.
RR ####
O conductivity value RR quarter.
LR ####
O conductivity value LR quarter.
LF ####
O conductivity value LF quarter.
P RF ####
O progressive average conductivity data RF quarter.
P RR ####
O progressive average conductivity data RR quarter.
P LR ####
O progressive average conductivity data LR quarter.
P LF ####
O progressive average conductivity data LF quarter.
To Next Page
Loading...
