Chapter 2 - page 7
Operator’s manual ASTRONAUT
M-HE.002.1003
Key (G4) Disease codes
To scroll through the codes press the key more than once. To change or enter a new code, press the C(Clear)-
key. First enter the new disease code and then the treatment. Then press the E(Enter)-key. Treatment "00" at
disease code means that the treatment code should be deleted.
Key (G5) Cow data
Key (G6) Calendar data
LL xxyy
O/I disease code ##, treatment type yy. A total of five disease codes
with treatments can be programmed.
COW ####
O/I cow number.
ACT ###
O/I activity deviation percentage.
RESP ####
O responder number.
GRPNR #
O group number (maximum of 9).
NGRP ##
O/I next group number after the PC has communicated with the
Controller.
SEPNR ##
O/I separation function number.
NUMBER ##
O/I number of cow separations.
LACT ###
O number of days a cow is in lactation.
INHEAT? or N
O/I ? or N, depending on whether or not there is an in heat alarm.
When reported in heat by means of data change (?, change N
into Y), the actual date is entered in the field in heat of the X-pert
programme.
INSEM? or N
O/I ? or N, depending on whether or not there is an insemination
alarm. If insemination is reported by means of data change (?,
change N into Y), the actual date is entered in the field insem of
the X-pert programme.
INCALF?, N
O/I ? or N, depending on whether or not there is an in calf alarm.
IN CALF Y
O Yes, cow is in calf. If reported in calf by means o data change (?,
change N into Y), Yes is entered in the field in heat of the X-pert
programme.
DRY?, N
O/I ? or N, depending on whether or not there is a dry off alarm.
DRY Y
O Yes, cow is dried off. When reporting dry off by means of data
change (?, change N into Y), the actual date is entered in the field
dry off of the X-pert programme.
To Next Page
Loading...
