Chapter 3 - page 23
Operator’s manual ASTRONAUT
M-HE.002.1003
Movement inductor on or off. As soon as you end this option, the inductor
(where fitted) is switched off. Power supply continues, contrary to operation
after milking. Always test the voltage of the expelling shock with a tester and
never with a multimeter.
Feeding "on" or "off".
Through opening and closing of a relay, the robot reports its non-operation
to third parties.
Closed switch → in operation
Open switch → out-of-operation.
This screen indicates if the robot receives the out of operational signal.
The screen indicates if the infrared sensor detects an object within the box.
The sensor is so adjusted that it does detect cows, but not any small
(domestic) animals [limit of 80 cm (31 in.)] from floor level.
This screen is used to synchronise the time of the robot with the time of the
VCPC (Cattle Code Process Controller).
After choosing "yes", a message will be displayed on the screen with the
adjusted or previous time. Necessary when changing over from winter to
summertime and alternately.
Inquire the number of a cows responder which is close to the aerial in the
front of the manger.
on
Shock on
off
on
Feeding
off
on
Robot
Operational
off
Robot
Operational
Photocell
no
Time from VCPC yes
VCPC
no
Get responder yes
no
To Next Page
Loading...
