Figure 45. 7mm drive backplane installation (top)
a. Put the backplane down on the cage as shown.
b.
Install the two screws to secure the top backplane in place.
Step 4. Connect the cables to the system board assembly and the backplane. See
Chapter 6 “Internal
cable routing” on page 249
. If the cable connectors come with protective dust caps, make sure to
remove them before plugging in.
After you finish
Complete the parts replacement. See “Complete the parts replacement” on page 246.
Demo video
Watch the procedure on YouTube
CMOS battery replacement
Use this information to remove and install the CMOS battery.
Remove the CMOS battery
Use this information to remove the CMOS battery.
About this task
The following tips describe information that you must consider when removing the CMOS battery.
• Lenovo has designed this product with your safety in mind. The lithium CMOS battery must be handled
correctly to avoid possible danger. If you replace the CMOS battery, you must adhere to local ordinances
or regulations for battery disposal.
• If you replace the original lithium battery with a heavy-metal battery or a battery with heavy-metal
components, be aware of the following environmental consideration. Batteries and accumulators that
contain heavy metals must not be disposed of with normal domestic waste. They will be taken back free
of charge by the manufacturer, distributor, or representative, to be recycled or disposed of in a proper
manner.
94
ThinkSystem SR630 V3 User Guide
To Next Page
Loading...
